Symbols
The navigation system may have a feature that lets the driver view symbols on the navigation screen while using the rear vision camera.
The Ultrasonic Rear Park Assist (URPA) system must not be disabled to use the caution symbols.
If URPA has been disabled and the symbols have been turned on, the Rear Parking Assist Symbols Unavailable error message may display. See Ultrasonic Parking Assist on page 9‑34.
The symbols appear when an object has been detected by the URPA system. The symbol may cover the object when viewing the navigation screen.
To turn the symbols on or off:
1. Make sure that URPA has not been disabled.
2. Shift into P (Park).
3. Press the MENU hard key to enter the configure menu options, then press the MENU hard key repeatedly until Display is selected or touch the Display screen button.
4. Select the Rear Camera Options screen button. The Rear Camera Options screen will display.
5. Touch the Symbols screen button. The screen button will be highlighted when on.
See also:
Pairing a Phone
1. Press and hold for two seconds.
2. Say “Bluetooth.” This command can be skipped.
3. Say “Pair.” The system responds with instructions and a four-digit Personal Identification Number (PIN ...
Power Windows
Crew Cab Shown
If available, the power window switches are located on each door.
The driver door also has a switch for the passenger and rear windows.
Push the switch to lower the window. Pull ...
Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
If the headlamps are off or in the low-beam position, pull the turn signal lever toward you to momentarily switch to high be ...