Shifting out of Park

The vehicle is equipped with an electronic shift lock release system.

The shift lock release is designed to:
• Prevent ignition key removal unless the shift lever is in P (Park) with the shift lever button fully released, and
• Prevent movement of the shift lever out of P (Park), unless the ignition is in ON/RUN or ACC/ACCESSORY and the regular brake pedal is applied.

The shift lock release is always functional except in the case of an uncharged or low voltage (less than 9-volt) battery.

If the vehicle has an uncharged battery or a battery with low voltage, try charging or jump starting the battery. See Jump Starting on page 10‑78 for more information.

To shift out of P (Park):

1. Apply the brake pedal.

2. Press the shift lever button.

3. Move the shift lever to the desired position.

If you still are unable to shift out of P (Park):

1. Fully release the shift lever button.

2. While holding down the brake pedal, press the shift lever button again.

3. Move the shift lever to the desired position.

If you still cannot move the shift lever from P (Park), see your dealer.

    See also:

    Lamps
    Properly working headlamps, taillamps, and brake lamps are important to see and be seen on the road. • Signs that the headlamps need attention include dimming, failure to light, cracking, or damage ...

    Center Console Storage
    For vehicles with a center console storage, use the lever (A) on the front to open. ...

    To Use the Engine Coolant Heater
    1. Turn off the engine. 2. Open the hood and unwrap the electrical cord. The cord is secured to the Engine Compartment Fuse Block with a clip. Carefully remove the wire tie which bundles the electric ...