Using the “Digit Dial” Command
The digit dial command allows a phone number to be dialed by entering the digits one at a time.
After each digit is entered, the system repeats back the digit it heard followed by a tone.
If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.
To hear all of the numbers recognized by the system, say “Verify” at any time.
1. Press and hold
for two seconds.
2. Say “Digit Dial.” 3. Say each digit, one at a time, that you want to dial. After each digit is entered, the system repeats back the digit it heard followed by a tone. After the last digit has been entered, say “Dial.” Once connected, the person called will be heard through the audio speakers.
Using the “Re-dial” Command
1. Press and hold
for two seconds.
2. After the tone, say “Re-dial.” Once connected, the person called will be heard through the audio speakers.
See also:
Auxiliary Taillamp
To replace one of these lamps:
1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the interior trim access panel.
A. Attachment Nuts
B. Retaining Hook
3. Remove the five attachment ...
Windshield
For safety, appearance, and the best viewing, keep the windshield clean and clear.
• Signs of damage include scratches, cracks, and chips.
• Trained dealer technicians can inspect the windshield ...
Entry Lighting
The dome lamp, cargo lamp, and foot lamp inside the vehicle come on when any
door is opened, if the dome lamp is in the door position. In addition, these lamps
come on when the Remote Keyless Entr ...





