Finding a Station

BAND: Press to switch between AM, FM, or XM. The selection displays.

SEEK and (Tune): Turn to select radio stations.

SEEK: Press to go to the previous or next station and stay there. SEEK and SEEK: Press to go to the previous or next station and stay there. SEEK: Press to go to the previous or next station and stay there.

To scan stations, press and hold until a beep sounds. or until a beep sounds. until a beep sounds.

The radio goes to a station, plays for a few seconds, then goes to the next station. Press either arrow again to stop scanning.

The radio only seeks and scans stations with a strong signal that are in the selected band.

    See also:

    Key and Lock Messages
    REPLACE BATTERY IN REMOTE KEY This message displays if a Remote Keyless Entry (RKE) transmitter battery is low. The battery needs to be replaced in the transmitter. See “Battery Replacement” und ...

    Playing the Radio
    For vehicles equipped with the MyLink or IntelliLink infotainment system, see the separate MyLink/ IntelliLink Features and Functions Guide for more information. Audio Source VOL/ (Power/Volume): ...

    AM
    The range for most AM stations is greater than for FM, especially at night. The longer range can cause station frequencies to interfere with each other. For better radio reception, most AM radio stati ...