Finding a Station

BAND: Press to switch between AM, FM, or XM. The selection displays.

SEEK and (Tune): Turn to select radio stations.

SEEK: Press to go to the previous or next station and stay there. SEEK and SEEK: Press to go to the previous or next station and stay there. SEEK: Press to go to the previous or next station and stay there.

To scan stations, press and hold until a beep sounds. or until a beep sounds. until a beep sounds.

The radio goes to a station, plays for a few seconds, then goes to the next station. Press either arrow again to stop scanning.

The radio only seeks and scans stations with a strong signal that are in the selected band.

    See also:

    Shifting Into Two-Wheel Drive High
    Turn the knob to the Two-Wheel Drive High position. This can be done at any speed, except when shifting from Four-Wheel Drive Low. The indicator light will flash while shifting. It will remain on whe ...

    Adding Washer Fluid
    The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID LOW ...

    Storing Memory Positions
    To save into memory: 1. Adjust the driver seat, seatback recliner, and both outside mirrors. See Power Mirrors on page 2‑16 for more information. Not all vehicles will have the ability to sav ...