Gate Operator and Canadian Programming
If you have questions or need help programming the Universal Home Remote System, call 1-800-355-3515 or go to www.homelink.com.
Canadian radio-frequency laws require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for Universal Home Remote to pick up the signal during programming. Similarly, some U.S. gate operators are manufactured to time out in the same manner.
If you live in Canada, or you are having difficulty programming a gate operator or garage door opener by using the “Programming the Universal Home Remote System” procedures, regardless of where you live, replace Step 3 under “Programming the Universal Home Remote System” with the following:
Continue to press and hold the Universal Home Remote button while you press and release every two seconds (cycle) the hand-held transmitter button until the frequency signal has been successfully accepted by the Universal Home Remote.
The Universal Home Remote indicator light will flash slowly at first and then rapidly. Proceed with Step 4 under “Programming the Universal Home Remote System” to complete the training procedure.
See also:
If the Off Indicator Is Lit for an Adult-Size Occupant
If a person of adult-size is sitting in the front outboard passenger seat, but the off indicator is lit, it could be because that person is not sitting properly in the seat. Use the following steps ...
Voltmeter Gauge
When the engine is not running, but the ignition is turned on, this gauge shows the battery's state of charge in DC volts.
When the engine is running, this gauge shows the condition of the charging ...
OnStar®
If the vehicle is equipped with an active OnStar system, that system may also record data in crash or near crash-like situations.
The OnStar Terms and Conditions provides information on data collecti ...