Programming the Power Windows

If the battery on the vehicle has been recharged, disconnected, or replaced, windows with the express-up feature need to be reprogrammed for this feature to work. To program the window:

1. Close all doors with the ignition in the ACC/ACCESSORY, ON/RUN position, or when Retained Accessory Power (RAP) is active.

See Retained Accessory Power (RAP) on page 9‑20.

2. Press and continue to hold the window switch until the window is fully open.

3. Pull up and hold the window switch to close the window.

Continue to hold it briefly after the window is fully closed.

4. Repeat for each window that has the express-up feature.

    See also:

    Instrument Panel Illumination Control
    This control is located on the instrument panel, to the left of the steering column. (Instrument Panel Brightness): Turn clockwise or counterclockwise to brighten or dim the lights. ...

    Floor Mats
    WARNING If a floor mat is the wrong size or is not properly installed, it can interfere with the pedals. Interference with the pedals can cause unintended acceleration and/or increased stopping d ...

    Engine Cooling When Trailer Towing
    The cooling system may temporarily overheat during severe operating conditions. See Engine Overheating on page 10‑18. ...