Storing Memory Positions
To save into memory:
1. Adjust the driver seat, seatback recliner, and both outside mirrors.
See Power Mirrors on page 2‑16 for more information.
Not all vehicles will have the ability to save and recall the mirror positions.
2. Press and hold “1” until two beeps sound.
3. Repeat for a second driver position using “2.”
To recall, press and release “1” or “2.” The vehicle must be in P (Park). A single beep will sound.
The seat and outside mirrors will move to the position previously stored for the identified driver.
See Memory Seats on page 3‑7 and Vehicle Personalization (With DIC Buttons) on page 5‑46 for more information.
See also:
Unable to Connect to OnStar Message
If there is limited cellular coverage or the cellular network has reached maximum capacity, this message may come on. Push to try the call again or try again after driving a few miles into another ce ...
Battery Load Management
The vehicle has Electric Power Management (EPM) that estimates the battery's temperature and state of charge. It then adjusts the voltage for best performance and extended life of the battery.
When t ...
Radio Messages
Calibration Error: The audio system has been calibrated for the vehicle from the factory.
If Calibration Error displays, it means that the radio has not been configured properly for the vehicle and i ...