Auxiliary Taillamp

To replace one of these lamps:

1. Open the liftgate. See Liftgate on page 2‑9.

2. Remove the interior trim access panel.

A. Attachment Nuts

A. Attachment Nuts
B. Retaining Hook

3. Remove the five attachment nuts (A) securing the taillamp assembly to the liftgate.
4. Disengage the retaining hook (B) and pull the taillamp assembly out of the vehicle liftgate.
5. Disconnect the lamp wiring harness.

6. Turn the bulb socket counterclockwise and pull it out.

6. Turn the bulb socket counterclockwise and pull it out.
7. Pull the bulb straight out of the socket.
8. Install the new bulb.
9. Push the bulb socket in and turn it clockwise.
10. Reverse Steps 2 through 5 to reinstall lamp assembly.

    See also:

    Safety Locks
    The vehicle has rear door security locks to prevent passengers from opening the rear doors from the inside. Open the rear doors to access the security locks on the inside edge of each door. To set ...

    Power Steering Fluid (2.4L L4 Engine)
    The vehicle has electric power steering and does not use power steering fluid. ...

    Washer Fluid
    What to Use When adding windshield washer fluid, be sure to read the manufacturer's instructions before use. If the vehicle will be operating in an area where the temperature may fall below freezing, ...