Starter Switch Check
WARNING
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
1. Before starting this check, be sure there is enough room around the vehicle.
2. Firmly apply both the parking brake and the regular brake. See Parking Brake
on page 9‑33.> Do not use the accelerator pedal, and be ready to turn off the engine
immediately if it starts.> 3. Try to start the engine in each gear. The vehicle
should start only in P (Park) or N (Neutral). If the vehicle starts in any other
position, contact your dealer for service.
See also:
Center Console Storage
Vehicles with an upper and lower center console storage area have cupholders included.
Pull the lever (A) up to access the upper storage area. Raise the upper storage bin, then pull the lever (B) u ...
Checking Coolant
The vehicle must be on a level surface when checking the coolant level.
Check to see if coolant is visible in the coolant surge tank. If the coolant
inside the coolant surge tank is boiling, do not ...
Ignition Positions
The ignition switch has four different positions.
To shift out of P (Park), the ignition must be in ON/RUN or ACC/ ACCESSORY and the regular brake pedal must be applied.
A (STOPPING THE ENGINE/ LO ...