Voice Recognition
The voice recognition system uses commands to control the system and dial phone numbers.
Noise: The system may not recognize voice commands if there is too much background noise.
When to Speak: A tone sounds to indicate that the system is ready for a voice command. Wait for the tone and then speak.
How to Speak: Speak clearly in a calm and natural voice.
See also:
Hazard Warning Flashers
Hazard Warning Flasher:
Press this button located on the instrument panel below the audio system, to make the front and rear turn signal lamps flash on and off.
This warns others that you are hav ...
Adjusting the Speakers (Balance/Fade) (AM-FM Radio and AM-FM Radio with CD)
To adjust the balance or fade:
1. Press or press the
knob until the speaker control label displays.
2. To adjust the setting, do one of the following:
• Turn the knob.
• Press either SEEK ...
Shifting Out of Four-Wheel Drive Low
To shift from Four-Wheel Drive Low to Four-Wheel Drive High, AUTO or Two-Wheel Drive High, the vehicle must be stopped or moving less than 5 km/h (3 mph) with the transmission in N (Neutral) and the i ...