Storing Radio Station Presets

There are a few ways to store presets.

Up to 36 preset stations can be stored. AM, FM, and XM, if equipped, can be mixed.

1. From the AM, FM, or XM main page, press and hold one of the preset screen buttons located at the bottom of the screen. After a few seconds, a beep will be heard and the new preset information will display on that screen button.

2. Touch and hold a preset button to store the currently active station. After a few seconds, a beep will be heard and the new preset information will display on a small pop-up display at the bottom of the screen.

3. Repeat the steps for each preset.

To change the number of preset pages, see “Mixed-Band Presets” following for more information.

Recalling a Preset Station

To recall a preset station from a FAV page, do the following:

○ Press the FAV button on the faceplate to display the FAV pop-up. Select the desired preset from the pop-up.

○ Press the FAV screen button at the top bar to display the preset pop-up that appears at the bottom of the page. Press one of the preset screen buttons to go to the selected preset station.

○ In the AM, FM, or XM (if equipped) main page, press one of the preset screen buttons to go to the selected preset station.

    See also:

    Engine Hour Meter Display
    The Driver Information Center (DIC) can also display the number of hours the engine has run. To display the engine hours, turn the ignition off, then press and hold the reset button for at least four ...

    Engine Hours
    Press the vehicle information button until ENGINE HOURS displays. This display shows the total number of hours the engine has run. ...

    Stop/Tail/Turn Signal/ Sidemarker Lamp
    To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the two screw covers from the taillamp assembly. 3. Remove the two screws securing the taillamp asse ...