Headlamp High/Low-Beam Changer

Push the turn signal/lane change lever away from you and release, to turn the high Headlamp High/Low&-Beam Changer: Push the turn signal/lane change lever away from you and release, to turn the high beams on. To return to low beams, push the lever again or pull it toward you and release.

This indicator light turns on in the instrument panel cluster when the high&-beam

This indicator light turns on in the instrument panel cluster when the high&-beam headlamps are on.

    See also:

    Starting the Engine
    Move the shift lever to P (Park) or N (Neutral). The engine will not start in any other position. To restart the engine when the vehicle is already moving, use N (Neutral) only. Notice: Do not try to ...

    Leaving After Parking on a Hill
    1. Apply and hold the brake pedal. 2. Start the engine. 3. Shift into a gear. 4. Release the parking brake. 5. Let up on the brake pedal. 6. Drive slowly until the trailer is clear of the chocks. ...

    Compass Calibration Procedure
    1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section. Do not ...