Exterior Lamp Controls
The exterior lamp control is on the turn signal/lane change lever.
(Exterior Lamp Control): Operates
the exterior lamps. Turn to one of the following positions:
(Off): Briefly turn to this position
to turn the automatic light control off or on again.
AUTO (Automatic Headlamps): Turns the exterior lamps on and off automatically depending on the exterior light. The vehicle will default to the AUTO setting when it is first started.
(Parking Lamps): Turns on the parking
lamps together with the following:
○ Sidemarker Lamps
○ Taillamps
○ License Plate Lamps
○ Instrument Panel Lights
(Headlamps): Turns on the headlamps,
together with the previously listed lamps and lights.
See also:
Reprogramming a Single Universal Remote Button
To reprogram any of the three Universal Remote buttons, repeat the programming instructions earlier in this section, beginning with Step 2.
For help or information on the Universal Home Remote System ...
Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
To use the air compressor to inflate a tire with air only and not sealant:
If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning fl ...
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate trim.
2. Turn and pull the license plate lamp forward through the liftgate trim open ...