Safety Belts
This section of the manual describes how to use safety belts properly. It also describes some things not to do with safety belts.
WARNING
Do not let anyone ride where a safety belt cannot be worn properly. In a crash, if you or your passenger(s) are not wearing safety belts, injuries can be much worse than if you are wearing safety belts. You can be seriously injured or killed by hitting things inside the vehicle harder or by being ejected from the vehicle. In addition, anyone who is not buckled up can strike other passengers in the vehicle.
It is extremely dangerous to ride in a cargo area, inside or outside of a vehicle. In a collision, passengers riding in these areas are more likely to be seriously injured or killed. Do not allow passengers to ride in any area of the vehicle that is not equipped with seats and safety belts. Always wear a safety belt, and check that all passenger(s) are restrained properly too.
This vehicle has indicators as a reminder to buckle the safety belts. See Safety Belt Reminders on page 5‑11 for additional information.
See also:
Shutting the Engine Off After a Remote Start
To shut off the engine:
○ Press until the parking lamps
turn off.
○ Turn on the hazard warning flashers.
○ Insert the key and turn it to ON/ RUN and then back to LOCK/OFF. ...
Manual Liftgate
To unlock the liftgate, press the power door lock switch or press on the Remote Keyless Entry (RKE) transmitter twice.
See Remote Keyless Entry (RKE) System Operation on page 2‑3.
To open the ...
When the Light Flashes First and Then Is On Steady
If the light flashes for about a minute and then stays on, there may be a problem with the TPMS. If the problem is not corrected, the light will come on at every ignition cycle.
See Tire Pressure Mon ...