Using Voice Commands During a Planned Route

Cancel Route

1. Push “OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?” 2. Say “Yes.” System responds:. System responds:

“OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?” 2. Say “Yes.” System responds:

“OK, route canceled.” 3. Say “Goodbye.” Exits voice commands.

Route Preview

1. Push “OnStar ready,” then a tone.. System responds:

“OnStar ready,” then a tone.

2. Say “Route Preview.” System responds with the next three maneuvers.

3. Say “Goodbye.” Exits voice commands.

Repeat

1. Push “OnStar ready,” then a tone.. System responds:

“OnStar ready,” then a tone.

2. Say “Repeat.” System responds with the last direction given, then responds with “OnStar ready,” then a tone.

3. Say “Goodbye.” Exits voice commands.

Get My Destination

1. Push “OnStar ready,” then a tone.. System responds:

“OnStar ready,” then a tone.

2. Say “Get my destination.” System responds with miles to the destination, then responds with “OnStar ready,” then a tone.

3. Say “Goodbye.” Exits voice commands.

    See also:

    Windows
    WARNING Leaving children, helpless adults, or pets in a vehicle with the windows closed is dangerous. They can be overcome by the extreme heat and suffer permanent injuries or even death from heat s ...

    Unable to Connect to OnStar Message
    If there is limited cellular coverage or the cellular network has reached maximum capacity, this message may come on. Push to try the call again or try again after driving a few miles into another ce ...

    Warning Lights, Gauges, and Indicators
    Warning lights and gauges can signal that something is wrong before it becomes serious enough to cause an expensive repair or replacement. Paying attention to the warning lights and gauges could preve ...