Windshield Wipers
If the wiper motor overheats due to heavy snow or ice, the windshield wipers will stop until the motor cools and will then restart.
Although the circuit is protected from electrical overload, overload due to heavy snow or ice may cause wiper linkage damage.
Always clear ice and heavy snow from the windshield before using the windshield wipers.
If the overload is caused by an electrical problem and not snow or ice, be sure to get it fixed.
See also:
Cleaning Exterior Lamps/Lenses
Use only lukewarm or cold water, a soft cloth, and a car washing soap to clean exterior lamps and lenses.
Follow instructions under "Washing the Vehicle" later in this section. ...
What to Add
Use only new DOT 3 brake fluid from a sealed container. See Recommended Fluids
and Lubricants on page 11‑12.
Always clean the brake fluid reservoir cap and the area around the cap before
re ...
Sensors
The solar sensor, located in the defrost grille in the middle of the instrument panel, monitors the solar heat. Do not cover the solar sensor or the system will not work properly.
The interior te ...