Center High-Mounted Stoplamp (CHMSL) and Cargo Lamp
To replace one of these bulbs:

1. Remove the two screws and lift off the lamp assembly.
A. Cargo Lamp
B. Center High-Mounted Stoplamp (CHMSL) Bulb
2. On the reverse side of the lamp assembly, remove the bulb socket by turning it one quarter turn counterclockwise and pull it straight out.
3. Remove the bulb by pulling it straight out of the socket.
4. Install the bulb by pushing the bulb straight into the socket.
5. Install the bulb socket into the lamp asembly by turning it one quarter turn clockwise.
6. Reinstall the lamp assembly and tighten the screws.
See also:
California Fuel Requirements
If the vehicle is certified to meet California Emissions Standards, it is designed to operate on fuels that meet California specifications.
See the underhood emission control label. If this fuel is n ...
Battery Replacement
Replace the battery if the REPLACE BATTERY IN REMOTE KEY message displays in
the DIC. See ЃgReplace Battery in Remote KeyЃh under Key and Lock Messages on page
5.29.
The battery is not recharge ...
Vehicle Messages
Messages displayed on the DIC indicate the status of the vehicle or some action may be needed to correct a condition. Multiple messages may appear one after another.
The messages that do not require ...





