Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps

To replace one of these bulbs:

1. Open the tailgate. See Tailgate on page 2‑10 for more information.

2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull rearward until disengaging the two outer pins on the taillamp assembly from the vehicle.

2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull rearward until disengaging the two outer pins on the taillamp assembly from the vehicle.

B. Back-up Lamp A. Stoplamp/Taillamp/Turn Signal Lamp
B. Back-up Lamp

3. Turn the bulb socket counterclockwise to remove it from the taillamp assembly.

4. Pull the old bulb straight out from the socket.

5. Press a new bulb into the socket and turn the socket clockwise into the taillamp assembly.

6. Reinstall the taillamp assembly.

    See also:

    Distracted Driving
    Distraction comes in many forms and can take your focus from the task of driving. Exercise good judgment and do not let other activities divert your attention away from the road. Many local govern ...

    New Vehicle Break-In
    Notice: The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines: • If you have all-wheel drive, keep your speed at 88 km/h (55 mp ...

    California Proposition 65 Warning
    Most motor vehicles, including this one, contain and/or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Engine exhaust, many parts and ...