Taillamps (Chassis Cab Models)

A. Backup Lamp
B. Stoplamp/Taillamp/Turn Signal Lamp
To replace one of these bulbs:
1. Remove the four screws.
2. Lift the lens off the lamp assembly.
3. Turn the old bulb counterclockwise and pull the it straight out from the socket.
4. Install a new bulb into the socket, turn it clockwise, and press it in until it is tight.
5. Reinstall the lens and the four screws.
See also:
Range Selection Mode
Range Selection Mode
The Range Selection Mode switch, if equipped, is located on the shift lever.
To enable the Range Selection feature:
1. Move the column shift lever to the M(Manual) position ...
Engine Oil Additives/Engine Oil Flushes
Do not add anything to the oil.
The recommended oils with the dexos specification and displaying the dexos certification mark are all that is needed for good performance and engine protection.
Engin ...
Object Detection System Messages
FORWARD COLLISION ALERT OFF
If your vehicle has the Forward Collision Alert (FCA) system, this message may
display if the FCA system cannot activate due to a temporary condition. See Forward
Coll ...





