Starter Switch Check
WARNING
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.
1. Before starting this check, be sure there is enough room around the vehicle.
2. Firmly apply both the parking brake and the regular brake.
See Parking Brake on page 9‑58.
Do not use the accelerator pedal, and be ready to turn off the engine immediately if it starts.
3. Try to start the engine in each gear. The vehicle should start only in P (Park) or N (Neutral).
If the vehicle starts in any other position, contact your dealer for service.
See also:
Certification Label
Label Example
A vehicle-specific Certification label is attached to the lower center pillar
on the driver side of the vehicle or on the rear edge of the driver door. The label
shows the size of ...
Brake Fluid
The brake master cylinder reservoir is filled with DOT 3 brake fluid as indicated
on the reservoir cap. See Engine Compartment Overview on page 10‑6 for the location
of the reservoir.
The ...
Brake Fluid
The brake master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap.
See Engine Compartment Overview on page 10‑6 for the location of the reservoir.
There ...





