Turning the System On and Off

The URPA system can be turned on and off using the rear park aid disable button located next to the radio.

The indicator light comes on when the system is disabled and turns off when the system is on.

The indicator light comes on when the system is disabled and turns off when the system is on.

When the system is off, PARK ASSIST OFF displays on the Driver Information Center (DIC). The message disappears after a short period of time.

URPA defaults to the on setting each time the vehicle is started.

Notice: If you use URPA while the tailgate is lowered, it may not detect an object behind your vehicle, and you might back into the object and damage your vehicle. Always verify the tailgate is closed when using URPA or turn off URPA when driving with the tailgate lowered.

    See also:

    Sensors
    The solar sensor, located in the defrost grille in the middle of the instrument panel, monitors the solar heat. Do not cover the solar sensor or the system will not work properly. The interior te ...

    Using the “Dial” or “Call” Command
    1. Press and hold for two seconds. 2. Say “Dial” or “Call.” 3. Say the entire number without pausing, or say the name tag. Once connected, the person called will be heard through the audio ...

    Making a Call
    Calls can be made using the following commands. Dial or Call: The dial or call command can be used interchangeably to dial a phone number or a stored name tag. Digit Dial: This command allows a phon ...