Making a Call

Calls can be made using the following commands.

Dial or Call: The dial or call command can be used interchangeably to dial a phone number or a stored name tag.

Digit Dial: This command allows a phone number to be dialed by entering the digits one at a time.

Re-dial: This command is used to dial the last number used on the cell phone.

    See also:

    Using Voice Commands During a Planned Route
    Cancel Route 1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?” 2. Say “Ye ...

    Flash-to-Pass
    This feature is used to signal to the vehicle ahead that you want to pass. If the headlamps are off or in the low-beam position, pull the turn signal lever toward you to momentarily switch to high be ...

    Adding Washer Fluid
    Open the cap with the washer symbol on it and add washer fluid until full. See Engine Compartment Overview on page 10‑6 for reservoir location. Notice ○ When using concentrated washe ...