Voice Pass-Thru

Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature.

To access contacts stored in the cell phone:

1. Press and hold 2. Say “Bluetooth.” This command can be skipped. for two seconds.

2. Say “Bluetooth.” This command can be skipped.

3. Say “Voice.” The system responds “OK, accessing <phone name>.” The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.

    See also:

    Radio Data System (RDS)
    The Radio Data System (RDS) feature is available for use only on FM stations that broadcast RDS information. This system relies upon receiving specific information from these stations and only works w ...

    Disconnecting the RVC
    The rear vision camera must be disconnected if the tailgate needs to be removed. To disconnect the camera: 1. Remove the license plate. 2. Disconnect the camera connectors from the chassis harness, ...

    How to Check Lubricant
    To get an accurate reading, the vehicle should be on a level surface. 1500 Series A. Fill Plug B. Drain Plug All Except 1500 Series A. Fill Plug B. Drain Plug • When the differential is c ...