Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
If the headlamps are off or in the low-beam position, pull the turn signal lever toward you to momentarily switch to high beams.
Release the lever to turn the high-beam headlamps off.
See also:
New Vehicle Break-In
Notice: The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines:
• Keep the vehicle speed at 88 km/h (55 mph) or less for the firs ...
Error Messages
If Disc Error displays and/or the disc comes out, it could be for one of the
following reasons:
○ The disc has an invalid or unknown format.
○ The disc is very hot. Try the disc again ...
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the license plate lamps to the liftgate trim.
2. Turn and pull the license plate lamp forward through the liftgate trim open ...